Understanding the Basic Connection of Through-Beam Sensors
In industrial automation, through-beam photoelectric sensors consist of a separate emitter and receiver. These devices are not wired in series with each other in a traditional electrical sense; instead, they function as a paired system. The emitter continuously sends a light beam to the receiver. When an object interrupts this beam, the receiver's output changes state. The key point is that the emitter and receiver are connected to the power supply independently, not in a series circuit that would affect each other’s power delivery.
Series Connection: What It Really Means for Sensors
When engineers ask if sensors are "in series," they often refer to the output wiring of multiple sensors in a control system. For through-beam sensors, the receiver's output (usually NPN or PNP) can be wired in series with other sensors' outputs to create a logical AND condition. This means all sensors must detect an object simultaneously for the control system to receive a signal. However, the sensor’s internal components—emitter and receiver—are not physically in series; they are separate units sharing only an optical path.

Practical Wiring Examples in Automation Systems

Consider a safety light curtain or a multi-sensor detection line. If you connect the outputs of three through-beam receivers in series, the final output goes high only when all three beams are uninterrupted. This is common in conveyor belt systems for part counting. The emitter side is typically wired in parallel to a single power source because all emitters need constant power to function. Miswiring the emitters in series would cause voltage drops and unreliable operation.
Common Misconceptions Among Technicians
A frequent error is assuming that the emitter and receiver pair must share a common electrical connection. In reality, they only share a common ground for noise reduction. Some technicians attempt to wire multiple emitter-receiver pairs in series on the same power supply, which leads to insufficient voltage for the last receiver. Always refer to the manufacturer’s datasheet: most through-beam sensors require a dedicated 24V DC supply per pair, not a series chain.
Technical Recommendations for Reliable Installation
For installations requiring multiple through-beam sensors, wire each receiver’s output in parallel to a programmable logic controller (PLC) input for independent monitoring. If series connection is needed for safety logic, use relay logic or a safety controller to combine signals. Ensure the power supply can handle the total current draw of all emitters and receivers. Use shielded cables for the receiver to prevent interference, as the optical path is more critical than the electrical one.